Hammerite Hammered Direct To Rust Metal Paint - Aerosol
Hammerite Hammered Direct To Rust Metal Paint - Aerosol
Overview
Hammerite Hammered Direct To Rust Metal Paint, comes in a handy aerosol spray can for easy application. It’s specially formulated to perform as a primer, undercoat and topcoat in one. This product can be applied directly to rust and dries quickly to a subtle hammered effect with a metallic sheen.
Hammerite hammered finish spray paint comes in Black, White and Silver and can be used directly on to metal doors, garden furniture, gates and railings.
- Hammered effect with a metallic sheen
- Up to 8 years rust protection
- Ultra tough - excellent weather resistance
- Smooth glossy finish
| Area | Exterior |
| Recommended Use | Metal Surfaces |
| Base | Solvent based |
| Coverage | 400ml covers up to 0.5m² |
| Drying Time | Touch dry 1-2 hours |
| Re-Coat Time | 4 hours |
| Recommended Coats | 3 or 4 coats |
| Application Method | Aerosol |
| VOC Levels | Very High |
Preparation
Always ensure the surface to be treated is clean, dry and free from any dust, dirt, grease, flaking paint or rust.
- Remove any loose paint and debris with a wire brush.
- Remove dirt and dust with diluted detergent.
- Remove grease with Hammerite Brush Cleaner and Thinners, then rinse with clean water and allow to dry.
- On bare zinc, aluminium and galvanised surfaces, firstly apply Hammerite Special Metals Primer.
Application
Before applying Hammerite Hammered Direct To Rust Metal Paint - Aerosol test a small area to ensure you are happy with the colour and finish.
- Spray a test patch of Hammerite Direct to Rust Metal Paint onto painted surfaces and leave for 1 hour.
- If there is no reaction apply Hammerite Direct to Rust Metal Paint directly to surface.
- If there is a reaction remove all paint before applying Hammerite Direct to Rust Metal Paint.
- For best results store the aerosol at room temperature for two hours prior to use.
- Shake can vigorously in a vertical motion, until the agitator ball is heard and continue to shake for a further 3 minutes.
- Spray in light even strokes from a distance of 15cm to avoid runs.
- Do not concentrate spray on one spot.
- Apply at least 3-4 coats for maximum protection.
- Allow 15 minutes between coats .
- Between coats invert can and spray for 2 seconds to avoid blockages.
- Touch dry 15 minutes, recoat after 15 minutes.
Note: Always follow the manufacturer instructions found on the tin.