Overview

Geocel Joiners Mate Wood Adhesive is a clear Polyurethane adhesive that sets in just 5 minutes. This one-part adhesive is easy to apply, with a standard sealant gun, ideal for both interior and exterior applications, and bonds wood, metal, stone, concrete, brick, masonry, and various plastics. This thixotropic gel offers exceptional bond strength, is weather and seawater proof, and resists most chemicals and acids, making it perfect for vertical joints and versatile use.

• High strength bond
• Sets in just 5 minutes
• Suitable for indoor & outdoor use - horizontal & vertical
• Weather proof & Seawater proof
• Can be worked, shaped and painted

Area	Interior & Exterior
Recommended Use	Wood, metal, concrete and various plastics. Unsuitable for polyethylene, polypropylene, Teflon or nylon.
Drying Time	Working Time: 5min Press Time: 30min at +15°C up to +20°C & 2hrs at +10°C Full Cure: After 21hrs approx. 90% of ultimate strength
Clean Up	Remove as much product as possible from the equipment before cleaning following manufacturer's recommendations

Preparation

The surfaces should be clean, free from dust, grease, clean surfaces with Geocel Universal Cleaning Wipes . To achieve maximum bond strength and assist cure, slightly moisten one surface with a damp cloth.

Application

If possible test on a small area before you start to ensure compatibility

One of the surfaces must be porous, abrade non-porous surfaces.

• To achieve maximum bond strength and assist cure, slightly moisten one surface with a damp cloth. Do not over wet
• Remove nozzle and cut the tip of the cartridge taking care not to damage the thread.
• Replace nozzle and cut cleanly at an angle of 45 degrees.
• Apply using a standard sealant gun. Wearing gloves is recommended.
• Apply adhesive evenly to one surface; only apply between 5°C and 30°C. If necessary, cover large surfaces with a fine-toothed spreader.
• Assemble parts IMMEDIATELY and clamp for 5-10mins at 20°C, (longer at lower temperatures). After this time, the joint may be easily handled. Final and full bond strength will be achieved after 30 minutes.

NOTE: The product foams slightly on application to fill small gaps. Any excess foam/adhesive must be removed with acetone before the product sets, or with a sharp chisel once set.

Always follow manufacturer's instructions found on the packaging

Aftercare & Storage

Close properly after use and store in a cool, frost free place. Can be stored approx 12 months when stored in a cool, frost free place. Less once cartridge has been opened